Inasmuch as Dan (Grimmund) has indicated in another post that he is using CT LBB5 HG to design scout ships I wonder if anyone has tried to 'upgrade' the performance (while retaining the other specs) of the scout ship using the CT LBB2 design sequence?
--------------------------------------------
On Thu, 10/23/14, Phil Pugliese (via tml list) <nobody@simplelists.com> wrote:

 Subject: [TML] Original CT LBB's scoutship vs CT HG scoutship?
 To: tml@simplelists.com
 Date: Thursday, October 23, 2014, 11:20 AM

 This email was sent from
 yahoo.com which does not allow forwarding of emails via
 email lists. Therefore the sender's email address (philpugliese@yahoo.com)
 has been replaced with a dummy one. The original message
 follows:

 As I recall, the
 legacy 3I scout ship was originally designed using the
 original set of CT LBB's.

 Has anyone tried using CT LBB5 (HG) to design a
 similar vessel?

 As I
 recall, there *were* some differences 'tween the two.
 (In fact, I believe CT HG even had a comment
 that it was acceptable to design ships up to 1000dT's
 under either system)
 --------------------------------------------------------------------------------------------------------------------------------------------------------------------

 -----
 The
 Traveller Mailing List
 Archives at http://archives.simplelists.com/tml
 Report problems to listmom@travellercentral.com
 To unsubscribe from this list please goto
 http://www.simplelists.com/confirm.php?u=EwREIRgLK8vaUEhNlnoNdSGKwnjoID8a